Technical Mcqs Objective Questions { Transistors and Applications }

Home // Technical Mcqs // Transistors and Applications

1. The primary function of the bias circuit is to

A. hold the circuit stable at VCC

B. hold the circuit stable at vin

C. ensure proper gain is achieved

D. hold the circuit stable at the designed Q-point

2. A JFET

A. is a current-controlled device

B. has a low input resistance

C. is a voltage-controlled device

D. is always forward-biased

3. The capacitor that produces an ac ground is called a(n)

A. coupling capacitor

C. bypass capacitor

4. In a class B push-pull amplifier, the transistors are biased slightly above cutoff to avoid

A. crossover distortion

B. unusually high efficiency

C. negative feedback

D. a low input impedance

5. The depletion-mode MOSFET

A. can operate with only positive gate voltages

B. can operate with only negative gate voltages

C. cannot operate in the ohmic region

D. can operate with positive as well as negative gate voltages

6. Three different points are shown on a dc load line. The upper point represents the

A. minimum current gain

B. quiescent point

C. saturation point

D. cutoff point

7. Which of the following conditions are needed to properly bias an npn transistor amplifier?

A. Forward bias the base/emitter junction and reverse bias the base/collector junction.

B. Forward bias the collector/base junction and reverse bias the emitter/base junction.

C. Apply a positive voltage on the n-type material and a negative voltage on the p-type material.

D. Apply a large voltage on the base.

Page 1 of 3

1 23 »