A Best Way To Crack Gorenment Job Exams

Technical Mcqs Objective Questions {  Inductors }



64. When used as a filter, an inductor is
A. placed in series with the load and aids any current changes
B. placed in parallel with the load and aids any current changes
C. placed in parallel with the load and opposes any current changes
D. placed in series with the load and opposes any current changes
Discuss in Forum
65. A loaded transformer will achieve mutual induction when:
A. secondary current increase causes a primary current decrease
B. primary current is increased by an increase in secondary current
C. primary current is decreased by an increase in secondary current
D. secondary current decrease causes a primary current increase
Discuss in Forum
66. Which transformer turns ratio is needed to match two 16-ohm parallel devices to an output of 22.2 ohms?
A. 1.38:1
B. 1.67:1
C. 0.72:1
D. 0.60:1
Discuss in Forum
67. A transformer will have:
A. primary and secondary windings
B. primary and secondary current
C. primary wattage producing secondary current
D. different frequencies for the primary and
Discuss in Forum
68. What is the phase angle of a 24 Vac parallel RL circuit when R = 45 ohms and XL = 1100 ohms?
A. 0.001 degrees
B. 2.300 degrees
C. 87.600 degrees
D. 89.900 degrees
Discuss in Forum
69. A winding of wire can be called
A. an inductor
B. a coil
C. a choke
D. All of the above
Discuss in Forum
70. What happens when moving expanding lines of force encounter a conductor?
A. Current increases.
B. Voltage is induced.
C. Resistance is reduced.
D. Power is increased.
Discuss in Forum

Page 10 of 14

« 8 9  10  1112 »