50. It is required to connect two parallel shafts, the distance between whose axes is small and variable. The shafts are coupled by
A.Universal joint
B.Knuckle joint
C.Oldham's coupling
D.Flexible coupling
51. The c.g. of a link in any mechanism would experience
A.No acceleration
B.Linear acceleration
C.Angular acceleration
D.Both angular and linear accelerations
52. In elliptical trammels
A.All four pairs are turning
B.Three pairs turning and one pair sliding
C.Two pairs turning and two pairs sliding
D.One pair turning and three pairs sliding
53. In automobiles the power is transmitted from gear box to differential through
A.Bevel gear
B.Universal joint
C.Hooke's joint
D.Knuckle joint
54. Crowning on pulleys helps
A.In increasing velocity ratio
B.In decreasing the slip of the belt
C.For automatic adjustment of belt position so that belt runs centrally
D.Increase belt and pulley life
55. Idler pulley is used
A.For changing the direction of motion of the belt
B.For applying tension
C.For increasing velocity ratio
D.All of the above
56. In multi-V-belt transmission, if one of the belt is broken, we have to change the
A.Broken belt
B.Broken belt and its adjacent belts
C.(e) all the belts
D.There is no need of changing any one as remaining belts can take care of transmission of load
Page 8 of 43