A Best Way To Crack Gorenment Job Exams

Mechanical Engineering Objective Questions { Theory of Machines }



141. For heavy thrust, the contact angle in tapered roller bearings varies between
A.28?30?
B.5?10?
C.2?5?
D.15-20?
Discuss in Forum

142. In a well greased ball bearing, the coefficient of friction may be
A.0.01 to 0.1
B.0.1 to 0.25
C.0.25 to 0.35
D.0.35 to 0.5
Discuss in Forum

143. Maximum fluctuation of energy is the
A.Variation of energy above and below the mean resisting torque line
B.Ratio of maximum and minimum energies
C.Difference between the maximum and minimum energies
D.Ratio of the maximum fluctuation of energy to the work done per cycle
Discuss in Forum

144. Coefficient of fluctuation of energy is the
A.Variation of energy above and below the mean resisting torque line
B.Ratio of maximum and minimum energies
C.Difference between the maximum and minimum energies
D.Ratio of the maximum fluctuation of energy to the work done per cycle
Discuss in Forum

145. Coefficient of fluctuation of speed is the
A.Variation of energy above and below the mean resisting torque line
B.Ratio of maximum fluctuation of speed to the mean speed.
C.Difference between the maximum and minimum energies
D.Ratio of the maximum fluctuation of energy to the work done per cycle
Discuss in Forum

146. In the rim type of flywheel, the major mass is
A.Concentrated around the periphery
B.Concentrated at the centre
C.Contributed due to arms
D.Ineffective
Discuss in Forum

147. The supply of working fluid to the engine to suit the load conditions is controlled by
A.Meyer's expansion valve
B.D-slide valve
C.Flywheel
D.Governor
Discuss in Forum

Page 21 of 43

« 19 20  21  2223 »