624. Standard milling arbor size is
A.25.4 mm
B.32 mm
C.31.75 mm
D.All of the above
625. Milling machine is classified as horizontal or vertical type, depending on the position of
A.Spindle
B.Workpiece
C.Milling cutter
D.Work table or bed
626. Burnishing is an operation of
A.Heat treatment
B.Deep boring
C.Gear finishing
D.Surface treatment
627. To obtain fine finish cuts in milling
A.The cutting speed should be decreased and the feed increased
B.The cutting speed should be increased and the feed decreased
C.Both the cutting speed and feed should be decreased
D.Both the cutting speed and feed should be increased
628. The arbor of the milling machine is used to hold
A.Cutting tool
B.Spindle
C.Over arm
D.Mandrel
629. Very thin chips with end mills
A.Dull the cutting edge quickly
B.Improve tool life
C.Sharpen the cutting edge
D.Cause chipping of the cutting edge cause tool breakage
630. Plain milling cutters should be
A.Smaller than the width of the flat surface to be machined
B.Wider than the flat surface to be machined
C.Equal to width of flat surface to be machined
D.There is no such criterion
Page 90 of 139