A Best Way To Crack Gorenment Job Exams

Mechanical Engineering Objective Questions { Production Technology }



519. With H.S.S. tools, highest cutting speed is used while machining
A.Cast iron
B.Aluminium
C.Brass
D.Bronze
Discuss in Forum

520. In machining, chips break due to
A.Plasticity
B.Ductility
C.Toughness
D.Work hardening
Discuss in Forum

521. When machining a hard and brittle metal like cast iron, the type of chips produced is
A.Continuous chip
B.Discontinuous chip
C.Continuous chip with built-up edge
D.No chips are produced
Discuss in Forum

522. The following type of chip is produced when machining ductile materials
A.Continuous chip
B.Discontinuous chip
C.Continuous chip with built-up-edge
D.No chips are produced
Discuss in Forum

523. The advantage of positive rake angles on cutters is that these
A.Use less power
B.Have less cutting pressures
C.Work well on soft and ductile materials
D.All of the above
Discuss in Forum

524. The following cutting fluid is used with carbide tools
A.Kerosene oil
B.No cutting fluid
C.Water
D.Water with oil
Discuss in Forum

525. The sector arm in indexing head is so adjusted that the number of holes between the beveled edges is equal to
A.No. of holes to be indexed
B.No. of holes to be indexed + 1
C.No. of holes to be indexed -1
D.No. of holes to be indexed + 2
Discuss in Forum

Page 75 of 139

« 73 74  75  7677 »