A Best Way To Crack Gorenment Job Exams

Mechanical Engineering Objective Questions { Power Plant Engineering }



134. Reheating of steam under ideal conditions takes place at constant
A.Entropy
B.Enthaply
C.Pressure
D.Temperature
Discuss in Forum

135. The maximum discharge through a chimney occurs when the height of chimney is
A.Infinitely long
B.Around 200 metres
C.Equal to the height of the hot gas column producing draught
D.Outside temperature is very low
Discuss in Forum

136. Proximate analysis of fuel is determination of percentage of
A.Carbon, hydrogen, nitrogen, sulphur, moisture
B.Fixed carbon, ash, volatile matter, moisture
C.Higher calorific value
D.Lower calorific value
Discuss in Forum

137. Which device is used in thermal power plants to reduce level of pollution
A.Induced draft fan
B.Smoke meter
C.Chimney
D.Precipitator
Discuss in Forum

138. Bomb calorimeter is used to determine
A.Higher calorific value at constant volume
B.Lower calorific value at constant volume,
C.Higher calorific value at constant pressure
D.Lower,calorific value at constant pressure
Discuss in Forum

139. Ultimate analysis of fuel is determination of percentage of
A.Carbon, hydrogen, nitrogen, sulphur, moisture
B.Fixed carbon, ash, volatile matter, moisture
C.Higher calorific value
D.(b) lower calorific value
Discuss in Forum

140. For combutsion of a fuel, following is essential
A.Correct fuel air ratio
B.Proper ignition temperature
C.02 to support combustion
D.All the three above
Discuss in Forum

Page 20 of 81

« 18 19  20  2122 »