A Best Way To Crack Gorenment Job Exams

Mechanical Engineering Objective Questions { Internal Combustion Engines }



288. All heat engines utilize
A.Low Heat Value of oil
B.High Heat Value of oil
C.Net Calorific Value Of Oil
D.Calorific Value of Fuel
Discuss in Forum

289. An engine indicator is used to determine the following
A.Speed
B.Temperature
C.Volume Of Cylinder
D.M.E.P. And I.H.P.
Discuss in Forum

290. Fuel oil consumption guarantees for I .C. engine are usually based on
A.Low Heat Value Of Oil
B.High Heat Value Of Oil
C.Net Calorific Value Of Oil
D.Calorific Value Of Fuel
Discuss in Forum

291. If the compression ratio of an engine working on Otto cycle is increased from 5 to 7, the %age increase in efficiency will be
A.2%
B.4%
C.8%
D.14%
Discuss in Forum

292. In case of gas turbines, the gaseous fuel consumption guarantees are based on
A.High Heat Value
B.Low Heat Value
C.Net Calorific Value
D.Middle Heat Value
Discuss in Forum

293. In a typical medium speed 4-stroke cycle diesel engine the inlet valve
A.Opens At 20° Before Top Dead Center And Closes At 35° After The Bottom Dead Center
B.Opens At Top Dead Center And Closes At Bottom Dead Center
C.Opens At 10° After Top Dead Center And Closes 20° Before The Bottom Dead Center
D.May Open Or Close Anywhere
Discuss in Forum

294. The pressure and temperature at the end of compression stroke in a petrol engine are of the order of
A.4 - 6 Kg/cm2 And 200 - 250°C
B.6 - 12 Kg/cm2 And 250 - 350°C
C.12 - 20 Kg/cm2 And 350 - 450°C
D.20 - 30 Kg/cm2 And 450 - 500°C
Discuss in Forum

Page 42 of 54

« 40 41  42  4344 »