A Best Way To Crack Gorenment Job Exams

Mechanical Engineering Objective Questions { Engineering Metrology }



183. The method of fractional coincidences in interferometry techniques is used for
A.Measurement of end gauges
B.Flatness of surface
C.Linear displacement measurements
D.Convexity/concavity of surfaces
Discuss in Forum

184. An optical gauge works on the principle of
A.Reflection of light rays
B.Polarisation of light rays
C.Interference of light rays
D.Refraction of light rays
Discuss in Forum

185. Involute fnnction of a gear is defmed as
A.(cos a ? a) radians
B.(sin a ? a) radians
C.(tan a ? a) radians
D.(cot a ? a) radians
Discuss in Forum

186. The pitch circle raidus rp and base circle radius rb of a gear are related by the following relationship (a = pressure angle)
A.Rb= rp cos a (b) rb? cos a
B.(c) rb = rp sin a (d) rb = rp tan a (e) rb= r, (tan ? a).
C.18.224. The undercutting in case of 14-1 degree full depth involute teeth occurs when the number of teeth is less than
D.(a) 10
Discuss in Forum

187. The undercutting in case of 14-1 degree full depth involute teeth occurs when the number of teeth is less than
A.10
B.32
C.18
D.25
Discuss in Forum

188. During the gear tooth cutting operation the undercutting may occur, due to the corners of the cutter biting into the true involute curve on the flank of the tooth. This is called interference. It can be avoided by
A.Increasing the addendum on the pinion and reducing on the gear wheel
B.Increasing the addendum on both pinion and gear wheel
C.Reducing the addendum on both pinion and gear wheel
D.Reducing the addendum on the pinion and increasing on the gear wheel
Discuss in Forum

189. A sine bar is used to measure
A.Surface roughness
B.Gear profiles
C.Internal tapers
D.External tapers
Discuss in Forum

Page 27 of 32

« 25 26  27  2829 »