A Best Way To Crack Gorenment Job Exams

Electronics Engineering Objective Questions { Power Semiconductor Devices and Their Applications }



232. The major application of chopper drive is in
A. traction
B. computers
C. heating furnances
D. miniature motors
Discuss in Forum

233. When transistors are used in series or parallel a snubber circuit is used to
A. control the current
B. control the voltage
C. limit di/dt
D. all of the above
Discuss in Forum

234. Which of the following VHF/UHF applications?
A. BJT
B. MOSFET
C. SIT
D.IGBT
Discuss in Forum

235. Which of the following thyristors are gate turned off device?I. Gate turned off thyristorII. Static induction thyristor III MOS-controlled thyristor
A. I only
B. II only
C. I and II only
D. 1,11 and III
Discuss in Forum

236. An ideal rectifier should have transformer utilisation factor (TUF) of 1. If the actual TUF is 3.5, it shows that
A. diode is underloaded
B. the transformer must be 3.5 times larger
C. the transformer should be only 1/3.5 times the ideal size
D. the ripple factor is low
Discuss in Forum

237. An ideal rectifier should have 1. Harmonic factor = 1 2. Transformer utilisation Factor = 1 3. Efficiency = 100% 4. Effective value of ac component of output voltage = 0
A. SITs and BJTs
B. IGBTs and MOSFETS
C. Power transformers transistor
D. Infrared light-emitting diode and a silicon phototransistor
Discuss in Forum

238. 'Thermal run away' of thyristor occurs
A. when the load is suddenly withdrawn
B. if the temperature of thyristor is high
C. in case forward anode-to-cathode voltage is greater than the forward break down voltage
D. in case gate current is high
Discuss in Forum

Page 34 of 36

« 32 33  34  3536 »