A Best Way To Crack Gorenment Job Exams

Civil Engineering Objective Questions { Surveying }



99. To orient a plane table at a point P roughly south of the mid-point of two inaccessible conical hill stations A and B in the plains, a point C is selected in line with AB and table is oriented at C by bringing ab in line with AB. A ray is then drawn towards P and at P the table is oriented by back ray method. The orientation so obtained, is
A. unique and correct
B. incorrect
C. manifold and correct
D. not reliable.
Discuss in Forum

100. Orientation of a plane table by solving two point problem is only adopted when
A. saving of time is a main factor
B. better accuracy is a main factor
C. given points are inaccessible
D. none of these.
Discuss in Forum

101. Accuracy of 'fix' by two point problem, is
A. bad
B. good
C. not reliable
D. unique.
Discuss in Forum

102. While working on a plane table, the correct rule is:
A. Draw continuous lines from all instrument stations
B. Draw short rays sufficient to contain the points sought
C. Intersection should be obtained by actually drawing second rays
D. Take maximum number of sights as possible from each station to distant objects.
Discuss in Forum

103. If the plane table is not horizontal in a direction at right angles to the alidade, the line of sight is parallel to the fiducial edge only for
A. horizontal sights
B. inclined sights upward
C. inclined sight downward
D. none of these.
Discuss in Forum

104. The smaller horizontal angle between the true meridian and a survey line, is known
A. declination
B. bearing
C. azimuth
D. dip.
Discuss in Forum

105. The vertical angle between longitudinal axis of a freely suspended magnetic needle and a horizontal line at its pivot, is known
A. declination
B. azimuth
C. dip
D. bearing.
Discuss in Forum

Page 15 of 60

« 13 14  15  1617 »