Automobile Engineering Objective Questions { Transmission System }

Home // Automobile Engineering // Transmission System

36. Which part of engine is having connection with pinion of starting motor?

C. Damper pulley

37. A flywheel in an Ie engine

A. Controls the supply of fuel to the engine

B. Controls the cyclic fluctuation of speed

C. Controls the speed variation due to load

D. All of the above

38. The problem of a gradual torque take-up when the vehicle is moving away from a standstill has been overcome with

A. The introduction of fluid coupling between engine and gear box

B. The introduction of epicyclic gear box between engine and final drive

C. The introduction of torque converter between engine and transmission gears

D. None of the above

39. The purpose of the sliding joint in a propeller shaft is to

A. Adjust the distance between gear box and differential

B. Avoid whirling motion of propeller shaft

C. Transfer power from gear box and differential

D. Allow easy disassembly of the propeller shaft for repairs

40. What is the remedy of the trouble loose flanged yoke?

A. Tighten it fully

B. Replace universal joint

C. Replace a part

D. None of the above

41. Which of the following is the essential devices for overdrive?

A. A free wheeling mechanism

B. A planetary gear set

C. Both A and B

D. None are correct

42. Double declutching is required in constant mesh transmission to

A. Equalize the speed of main shaft gear and the sliding dog

B. Provide direct gear

C. Equalize the speed of conutershaft gear and the sliding dog

D. None of these

Page 6 of 20

« 4 5 6 78 »