A Best Way To Crack Gorenment Job Exams

Automobile Engineering Objective Questions { Introduction of Automobile Engineering }



36. The chassis frame of vehicles is narrow at the front, because:
A. It gives smaller turning radius to the vehicle
B. Number of tyres is less at the front
C. Weight of the vehicle is less at the front
D. It helps to reduce the weight of the frame
Discuss in Forum
37. When the axle is pulled the bearing
A. Stays in the housing
B. Stays in the differential
C. Comes out with it
D. None of these
Discuss in Forum
38. An upraised part on the hood which directs the air flow into the engine compartment is called
A. Spoiler
B. Hotpipe
C. Hood scoop
D. Wings
Discuss in Forum
39. A . . . . . . . . is a horizontal surface at the back of a car and serves as a lid to the trunk.
A. Trunktop
B. Deck
C. Hood
D. Backlight
Discuss in Forum
40. In case of a four wheel driven vehicle
A. Clutch operating linkage is simplified
B. Cooling system is simplified
C. The road adhesion is increased
D. The road adhesion is decreased
Discuss in Forum
41. The front axle of a car has pivot centers 1.3 m apart. The angle of inside lock is 40! and the angle of the outside lock is 35!. What is the wheelbase of the car?
A. 5.5 m
B. 3.5 m
C. 4.5 m
D. 6.5 m
Discuss in Forum
42. . . . . . . . . in an automobile is the source of power.
A. Engine
B. Output
C. Steering system
D. Suspension system
Discuss in Forum

Page 6 of 35

« 4 5  6  78 »