A Best Way To Crack Gorenment Job Exams

Automobile Engineering Objective Questions { Introduction of Automobile Engineering }



78. The part that tends to keep the valve closed is called the
Discussion

79. Which of these falls under LMV (Light Motor Vehicle) category based on capacity?
Discussion

80. On the rear end of a crankshaft mounted
Discussion

81. The function of a universal Joint is to allow the propeller shaft to
Discussion

82. On the front end of a crankshaft is mounted.
Discussion

83. The ratio of main journal diameter and the cylinder bore in a car engme is approximately
Discussion

84. The minimum number of compression rings in an automotive engine is
Discussion

Page 12 of 35

« 10 11  12  1314 »