A Best Way To Crack Gorenment Job Exams

Automotive Engines MCQs

Automobile Engineering Objective Questions

Home / Automobile Engineering / Automotive Engines



148. The space left in the circumference of piston after cutting ring groove is called-
A. Slot skirts
B. Ring groove
C. Running part
D. Ring land
Discussion
149. In a clutch will coil springs, the wear of the clutch facing will cause the clamping load to
A. Increase
B. Decrease
C. Remain constant
D. Become infinite
Discussion
150. . . . . . . . . to combat carburettor icing and fuel line freeze.
A. Anti-icers
B. Anti rust agent
C. Detergents
D. None of these
Discussion
151. What is the factor that tend to increase brake temperature?
A. Load on vehicle
B. Speed of cehicle
C. Unbalanced braking
D. All are correct
Discussion
152. The operation of removing trapped air from the hydraulic braking system is known as
A. Trapping
B. Tapping
C. Bleeding
D. Cleaning
Discussion
153. The firing order in a four-stroke IC engine is
A. 1-2-3-4
B. 1-4-3-2
C. 1-3-4-2
D. 1-2-4-3
Discussion
154. Which of the following is the fuel feed system of a petrol engine?
A. Fuel tank
B. Fuel pump
C. Fuel filter
D. All are correct
Discussion

Page 22 of 91

« 20 21  22  2324 »