1. Which command would you place on interface connected to the Internet?
A.ip nat inside
B.ip nat outside
C.ip outside global
D.ip inside local

---

2. Which command will show you all the translations active on your router?
A.show ip nat translations
B.show ip nat statistics
C.debug ip nat
D.clear ip nat translations *

---

3. Which command would you place on interface on a private network?
A.ip nat inside
B.ip nat outside
C.ip outside global
D.ip inside local

---

4. Port Address Translation is also termed what?
A.NAT Fast
B.NAT Static
C.NAT Overload
D.Overloading Static

---

5. When creating a pool of global addresses, which of the following can be used instead of the netmask command?
A./ (slash notation)
B.prefix-length
C. no mask
D.block-size

---

6. Which of the following would be a good starting point for troubleshooting if your router is not translating?
A.Reboot.
B.Call Cisco.
C.Check your interfaces for the correct configuration.
D.Run the debug all command.

---

7. Which command will show you the summary of the NAT configuration?
A.show ip nat translations
B.show ip nat statistics
C.debug ip nat
D.clear ip nat translations *

---